FILM-FACED PLYWOOD - QUALITY GRADES The two available qualities of film-faced plywood are determined by the appearance of the panel surface Defect Grade I. II. Exfoliation and breaking of a film No Up to 1% of the surface Burnt film By the area of 4 cm2 and no more than 2 per m2 On condition of absence of the film damages Trails from dead knots and splits Without damages on the film surface and uncompromised glue bond Whitish stains and strips on a film Allowed Low spot No By depth of max. 0,2 mm Scratch Without damages on the film surface Splitting on the edge No No more than 5 mm on condition that is covered by waterproof paint Smudges of paint on a the surface max. within 5 mm from the edges Sticking of extraneous film slices No Allowed <a href="default.html">welde.at</a> |<a href="fimfaced_plywood_spec.html"> fimfaced_plywood</a> | <a href="fimfaced_plywood_quallity.html">fimfaced_plywood_quality</a> | <a href="fimfaced_plywood_results.html">fimfaced_plywood_results</a> | <a href="rawpoplar_plywood_spec.html">rawpoplar_plywood_spec</a> | <a href="rawpoplar_plywood_density.html">rawpoplar_plywood_density</a> |<br> <a href="rawpoplar_plywood_quality.html">rawpoplar_plywood_quality</a> |<a href="veneered_plywood_spec.html"> veneered_plywood_spec</a> | <a href="hardboard_plywood_spec.html">hardboard_plywood_spec</a> | <a href="sawn_timber_softwood.html">sawn_timber_softwood</a> | <a href="sawn_timber_hardwood.html">sawn_timber_hardwood</a> |<br> <a href="wood_products.html">wood_products</a> | <a href="about.html">about</a> | <a href="partners.html">partners</a> | <a href="representatives.html">representatives</a> | <a href="contact.html">contact</a> | <a href="inquiryform.html">inquiryform</a> | <a href="DE/default.html">welde.at-german version</a> |